The tool of choice for major stock removal, a scrub is not usually used parallel to the grain, but at an angle of 30 or more. The blade edge is ground with a 3″ radius, so it takes an aggressive cut. This is the tool to use to get stock into a condition where you then can use a smooth plane.
The curved cutting edge of the 1 1/2″ wide by 3/16″ thick blade gives a distinctive, hand-worked texture to the workpiece. This is a single-iron tool, meaning there is no cap iron or chip breaker. Set screws along the side prevent the blade from shifting sideways when it runs into a knot.
Blade is made from PM-V11 steel (Rc61-63). Plane measures 10 3/4″ 2 1/4″ and weighs 3 lb. The ductile cast iron body is accurately machined and ground so the sole is flat. A refined yet rugged performer.
Made in Canada.

Add a Review

Your email address will not be published. Required fields are marked *