Name: PRO-TECH 3 LIP CLASSIC BEAD CUTTER KP708010
SKU: ART-D37833
Availability: InStock

Description
Reviews (0)

Spindle cutter – 3 lip classic bead

Tungsten Carbide – 3 wing

The cutter is designed to be used with a stationary spindle moulder equipped with either a 3/4′ or 1/2′ spindle shaft.

The cutter can be configured to cut quarter rounds and coves

KP800020 – 3/4′ – 1/2′ spacer rings

Important:

Make sure the spindle moulder has a table opening of at least 140mm.
Designed for spindle moulders equipped with either a 1/2′ or 3/4′ spindle shaft.

consider safety for your health and the people around you
General safety suggestions: It is advisable to always have the following items nearby and in a good condition Eye protection clean and scratch free Hearing protection quality earmuffs Dust masks discard old and dirty masks Gloves for easy handling of material and hand protection

Wear Gloves	Eye Protection	Hearing Protection	Dust Mask

To use spindle cutters safely (and to get the best results from your spindle), the cutters need to be installed properly on the spindle shaft. Improper installation of your cutter can cause excessive chatter and could increase the likelihood that the bits will break when in use. There is also a risk of having the cutter ‘cold welded’ to the spindle shaft.

First of all, before beginning any moulding operation, check your cutter to make sure that it is clean and most of all, sharp. If the bit is dull, chipped, is excessively burnt or has any other defect, it should be sharpened or replaced before use.